Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 159)

Chapter 8
ATCA-7350 Installation and Use (6806800G59G) 159
Software Upgrade
8.1 Overview
This chapter describes how to upgrade software on the ATCA-7350 blade under Red Hat
Enterprise Linux 5.x.
The following components can be upgraded using the scripts which are part of the software
packages:
8.2 BIOS Upgrade
The "Flash_upd.sh" is a shell script to be used in a Linux environment for BIOS upgrade. It is
part of the cross-atca-7350-bios-x.y.z-r rpm package. Please ask your local sales
representative for obtaining this package. It enables the user to re-program and upgrade the
"BOOT" and "USER" flash devices of the ATCA-7350 blade.
Example: ATCAVxxx.ROM
This binary file must be used to to program the boot flash device.
Table 8-1 Software Upgrade Overview
Component Upgrade Script
All firmware
upd.sh
BIOS
flash_upd.sh
EEPROM
eeprom_upd.sh
FPGA
fw_upd.sh
IPMC firmware
fw_upd.sh
SDR information
fw_upd.sh
SOL firmware
fw_upd.sh
Please do not attempt this procedure unless you really want to re-program the device.The
BIOS binary image is part of the distribution.