Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 54)

Hardware Preparation and Installation
ATCA-7350 Installation and Use (6806800G59G) 54
2.7.2 Removal
2.7.2.1 Power Off
2.7.2.1.1 Checks Before Power-Off
Before power-off, you need to confirm that:
 Data has been saved on the ATCA-7350.
 No application runs on the ATCA-7350.
 The ATCA-7350 has quitted the operating system (OS).
2.7.2.1.2 Procedure
To power off the ATCA-7350, proceed as follows:
1. Wear the ESD-preventive wrist strap.
For details, see Wearing the ESD-Preventive Wrist Strap on page 34 .
 Before you remove an ATCA-7350 or RTM-ATCA-7x50, prepare packing materials, such
as an antistatic package.
 Before you remove an ATCA-7350 or RTM-ATCA-7x50, power off the ATCA-7350. For
details on how to power off the ATCA-7350, see
Power Off on page 54 .
The RTM-ATCA-7x50 is powered by the ATCA-7350 in the slot paired with the RTM slot. The
RTM-ATCA-7x50 does not support hot swap. You can remove the RTM only when the ATCA-
7350 is powered off or if the shelf power is off.