Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 43)

Hardware Preparation and Installation
ATCA-7350 Installation and Use (6806800G59G) 43
2. Lay the ATCA-7350 where the DIMM is to be installed on the antistatic desktop.
3. Take the DIMM out of the antistatic package.
4. Make sure that the two interface fixing clips of the DIMM socket are fully open. Adjust the
DIMM to align it with the DIMM socket.
5. Insert the DIMM in the socket along the guide rails, as shown in Figure 2-4 .
6. Make sure that the fixing clips are fastened or closed firmly as shown in Figure 2-4 .
Product Damage
Operate the fixing clips slightly to avoid breaking them or damaging the DIMM socket.
If there is a gap between the DIMM and the fixing clips, the DIMM is not installed properly. In
this case, open the fixing clips and remove the DIMM. Then, insert the DIMM again.