Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 49)

Hardware Preparation and Installation
ATCA-7350 Installation and Use (6806800G59G) 49
2.6.5.2 Replacing the Hard Disk
To replace the hard disk, proceed as follows:
1. Wear the ESD-preventive wrist strap.
For details, see Wearing the ESD-Preventive Wrist Strap on page 34 .
2. Remove the ATCA-7350 whose hard disk is to be replaced if the blade is powered down.
Keep the ATCA-7350 in the occupied slot and keep the ATCA handles closed if the hard disk
shall be replaced by hot-swap. See
Chapter 7, RAID 1 Operations, on page 135 for required
steps to perform the disk hot-swap.
For details, see
Removing the ATCA-7350 on page 55 .
3. Remove the finger on the hard disk holder in a direction as shown in Figure 2-7 to unlock
the hard disk.
4. Exert even force to pull the hard disk holder from the fixing bracket, as shown in Figure 2-7 .
5. Unfasten the four screws used to fasten the hard disk anticlockwise, as shown in Figure 2-7 .
6. Exert even force to pull the hard disk from the holder, as shown in Figure 2-7 .
7. Place the extracted hard disk in the antistatic package.
8. Take the new hard disk out of the antistatic package.
9. Install the new hard disk.
For details, see Installing the Hard Disk on page 46 .
10. Install the ATCA-7350 with the hard disk replaced if not already installed in the system.
For details, see Installing the ATCA-7350 in a Powered Shelf on page 51 .