Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 23)

Introduction
ATCA-7350 Installation and Use (6806800G59G) 23
Table 1-1 lists the functions of the ATCA-7350.
Table 1-1 Functions of the ATCA-7350
Function Description
Processing functions  Supports two quad-core LV Intel Xeon 5408 (2.13 GHz) processors
 Supports 12 MB L2 cache
 Supports up to four FB-DIMMs
 Supports DIMM capacities of 512 MB, 1 GB, 2 GB, 4 GB, or 8 GB.
The maximum installed board memory capacity is 32 GB
Interface functions  Provides 1GB onboard flash storage
 Provides two SAS ports on the front panel
 Provides two Ethernet Base interfaces (10/100/1000Base-T)
 Provides two Ethernet Fabric interfaces (1000Base-BX, 10GBASE-
BX if RTM-ATCA7350 installed)
 Provides one Ethernet Update Channel interface (1000Base-BX)
 Provides two USB 2.0 interfaces (compatible with USB 1.1)
 Provides serial port to access CPU and IPMC serial console
 Provides two SAS on-board hard disks
 The RTM-ATCA-7x50 that works with the ATCA-7350 provides a
monitor interface and a USB 1.1 interface. Through optional
daughter cards, the RTM can provide, 2 or 4 GE interfaces or 2 FC
interfaces. Only with RTM ATCA-7350 the system provides 10G
Ethernet on its fabric interfaces.
Management functions The ATCA-7350 provides the IPMC that is powered by system
management power. The IPMC is connected to the ShMC through the
redundant IPMB.
The IPMC provides the following functions:

Environmental sensors temperature, voltage
 System Event Logs
 Watchdog timer
 Power-on, power-off, cold reset
 SOL (Serial Over LAN)
 FRU Hot-swap management
 E-Keying control