Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 161)

Software Upgrade
ATCA-7350 Installation and Use (6806800G59G) 161
For safety reasons the fw_upd.sh script calculates an md5 check sum of the image and
compare it with the factory-calculated md5 value in .md5. If this
file is not available, the user is prompted to skip the test. If the checksums do not match the
user is prompted to continue without regard to the result of this test or not.
8.3.1 FPGA Upgrade
This section describes the upgrade of the FPGAvia fw_upd.sh. It is part of the atca-7350-
fw-x.y.z-r
rpm package. Please ask your local sales representative for obtaining this
package.
FPGA Upgrade
Follow the steps below.
1. Boot Linux on the ATCA-7350 blade or on a host blade with network access to a
'rmcp' capable shelf manager hosting the target ATCA-7350 to get a Linux shell
prompt.
2. Update the firmware using the update script:
$ ./fw_upd.sh [-U ] [-P ] [-n ]
[-s] [-t ] -i
Example:
update method via ’rmcp’ server
$ ./fw_upd.sh -i fpga -t 172.17.0.8
default update method using onboard IPMI KCS interface
$ ./fw_upd.sh -i fpga -t 172.17.0.8