Altera Arria V Avalon-ST - Manual (Page 42)

Signal Direction Description
rx_st_be[-1:0]
Output Byte enables corresponding to the
rx_st_data
. The byte enable
signals only apply to PCI Express Memory Write and I/O Write
TLP payload fields. When using 64-bit Avalon-ST bus, the width
of
rx_st_be
is 8 bits. When using 128-bit Avalon-ST bus, the
width of
rx_st_be
is 16 bits. This signal is optional. You can
derive the same information by decoding the
FBE
and
LBE
fields
in the TLP header. The byte enable bits correspond to data bytes
as follows:
•
rx_st_data[127:120]
=
rx_st_be[15]
•
rx_st_data[119:112]
=
rx_st_be[14]
•
rx_st_data[111:104]
=
rx_st_be[13]
•
rx_st_data[95:88]
=
rx_st_be[12]
•
rx_st_data[87:80]
=
rx_st_be[11]
•
rx_st_data[79:72]
=
rx_st_be[10]
•
rx_st_data[71:64]
=
rx_st_be[9]
•
rx_st_data[7:0]
=
rx_st_be[8]
•
rx_st_data[63:56]
=
rx_st_be[7]
•
rx_st_data[55:48]
=
rx_st_be[6]
•
rx_st_data[47:40]
=
rx_st_be[5]
•
rx_st_data[39:32]
=
rx_st_be[4]
•
rx_st_data[31:24]
=
rx_st_be[3]
•
rx_st_data[23:16]
=
rx_st_be[2]
•
rx_st_data[15:8]
=
rx_st_be[1]
•
rx_st_data[7:0]
=
rx_st_be[0]
This signal is deprecated.
rx_st_parity[-1:0]
Output
The IP core generates byte parity when you turn on Enable byte
parity ports on Avalon-ST interface on the System Settings tab
of the parameter editor. Each bit represents odd parity of the
associated byte of the
rx_st_data
rx_st_data bus. For example,
bit[0] corresponds to
rx_st_data[7:0]
rx_st_data[7:0], bit[1]
corresponds to
rx_st_data[15:8]
.
rx_bar_dec_func_
num[2:0]
Output Specifies which function the
rx_st_bar
signal applies to.
For more information about the Avalon-ST protocol, refer to the Avalon Interface Specifications.
Related Information
Avalon Interface Specifications.
2014.12.15
Avalon‑ST RX Component Specific Signals 4-5
Interfaces and Signal Descriptions Altera Corporation
Send Feedback