Delta MMC120 - Manual (Page 66)

66
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Event Step Number
Step
Field 0
R/
W 1 1 1
See Event Step Transfer Command for details on these commands.
See also:
Input Register Overview
Output Register Overview
Communicating with the MMC120
Support and Troubleshooting
Warranty
This motion controller shall be free from defects in materials and workmanship under
normal and proper use and service for a period of fifteen (15) months from the date of
shipment by Delta Computer Systems, Inc. (Delta) or Delta's authorized distributor so
long as the module was under warranty when shipped to the customer by the distributor.
The obligation of Delta under this warranty shall be limited to repairing or replacing this
motion controller or any part thereof which, in the opinion of Delta, shall be proved
defective in materials or workmanship under normal use and service during the warranty
period.
Repairs required because of obvious installation failures (burned resistors, traces, etc.) are
not covered and will be billed at standard repair rates.
Disclaimer of other Warranties: There are no other representations or warranties made
by Delta, express or implied. Delta expressly disclaims any and all implied
warranties, including any implied warranty of merchantability and any implied
warranty of fitness for a particular purpose. Further, Delta disclaims any liability for
special, consequential or incidental damages resulting from any breach of warranty by
Delta under this Agreement.
Module Return for Repair
Should a module require repair, refer to Technical Support for return details.
Troubleshooting
Programming Hints
The Programmable Controller is responsible for storing the initialization parameters used