7 jumpstart autoprogramming, 8 computer account, Jumpstart autoprogramming -32 – SilentKnight 5700 User Manual
Page 130: Computer account -32, N 7.7, N 7.8
Programming
151295
7-32
7.7
JumpStart Autoprogramming
To run JumpStart:
1.
Enter the installer code.
2.
Select 7 for Program Menu.
3.
Select 6 for JumpStart Autoprogramming.
4.
Press the
or
arrow to select “Yes” from the warning screen.
5.
Press
ENTER
.
7.8
Computer Account
An installer at the panel site can initiate communications between the panel and a computer running the
5660SKSS software (see also Section 8.4.18). In order for this communication to function properly both the
computer (running the software) and the control panel must have matching computer account numbers and
computer access codes.
Before you program in this location you should know how your control panel will communicate with the
downloading computer, either through direct connect (RS232 or USB) or via the phone lines (Internal Modem).
If the panel initiates the call to a downloading computer, a phone number must be programmed in the computer
accounts area. If the computer initiates the call then answering machine bypass (see Section 7.6.2.6) may need to
be selected.
To program computer account information:
1.
Enter the installer code.
2.
Select 7 for Program Menu.
3.
Select 7 for Computer Account.
4.
Enter the computer account number, then press
ENTER
.
5.
Enter the computer code (up to 7-digits), then press
ENTER
.
6.
Enter the phone number the panel will dial to connect to a downloading computer (up to 24-digits), then
press
ENTER
. See Table 7-7 for special dialing characters.
IMPORTANT!
JumpStart is intended to be used prior to performing any custom programming. Each time JumpStart is
executed, all options will be reset to their default values. Do not run JumpStart after you have configured
the system through programming.