SilentKnight 5700 - Manual (Page 113)

Model 5700 Installation and Operation Manual 151295
7-15
7.5 Point
You may need to change characteristics of individual input points (detectors and switches) even after using
JumpStart. This section explains how to change options for: type of point, latching/non-latching, silenceable/
non-silenceable, zone assignment (input points), detector accessory base options, group assignment (output
points), and point name.
7.5.1 Point Programming For SLC
To program for points, follow these steps:
1. Enter the installer code.
2. Select 7 for Program Menu.
3. Press 4 to enter point menu.
4. Press the or arrows to select the desired module. refer to Section 6.5 Quick Reference Table for avail-
able choices.
5. Enter the number of the point you wish to edit, then press ENTER .
6. Select the type of device by pressing the or arrows. Refer to Table 7-5 under the column heading
“Type Selection” for a list of choices.
Table 7-4: Point Programming
Module Type
Type
Selection
Function
Latching
Option
Comments
SLC Loop
UNUSED
SD
DETECTOR
PHOTO
ION
HEAT
PHOT DUCT
ION DUCT
2WIRE SMK
SD SUP
DET
SUP PHOTO
Latching
Non Latching
SUP ION
SUP HEAT
SK
DETECTOR
PHOTO
ION
HEAT
PHOT DUCT
ION DUCT
2WIRE SMK
ACCLIMATE
HEAT HT
PHOTO-HEAT
BEAM