SilentKnight 5700 - Manual (Page 128)

Programming 151295
7-30
10. Then press or ENTER . See Section 9 for reporting codes.
7.6.5.4 Single Key Acknowledge
When this feature is programmed Y (Yes) allows the user to press the ACK Key and display the oldest un-
acknowledged event in the system. Pressing ACK again will acknowledge the event, then display the next oldest
un-acknowledge event without pressing the or arrow keys.
7.6.6 Daylight Savings
To edit Daylight Savings:
Note: For UL installations the alarm verification time can not be less than 60 seconds.
1. Enter the installer code.
2. Select 7 for Program Menu.
3. Select 5 for System Options.
4. Select 7 for Daylight Savings.
7.6.6.1 Automatic Daylight Savings Adjustment
The control panel has an automatic DST (Daylight Saving Time) adjustment feature. Before January 2007, if this
feature is enabled (set to Yes), the system clock will switch to DST on the first Sunday in April at 2:00 a.m. and
revert to standard time on the last Sunday in October at 2:00 a.m. After January 2007, if this feature is enabled,
the system clock will start and end DST according to the settings made in Daylight Savings. If this feature is not
enabled (set to No) the Daylight Saving Time change is not made to the system clock.
To enable or disable DST adjustment continue programming from step 7 above:
5. Select Y (enabled) or N (disabled) by pressing the or arrow, then press ENTER .
7.6.6.2 Daylight Saving Time Start and End
This option lets you to adjust the week and month Daylight Saving Time (DST) starts and ends. For this feature
to work, you must enable (set to Yes) the DST option under Misc. Options 1 (see Section 7.6.8.2). You can view
and change the settings in this option anytime, however, settings will not take effect until 2007. The default
values for the DST Start and End options reflect the August 8, 2005 DST law that goes into effect in 2007:
DST Start: The second Sunday in March
DST End: The first Sunday in November
To set the start and end for Daylight Saving Time:
6. Press the or arrow to select the week (1st, 2nd, etc.) Daylight Saving Time starts, then press ENTER
to make your selection and move to the month setting.
7. Press the or arrow to select the month (January – December) Daylight Saving Time starts, then press
ENTER to make your selection and move to the DST End option.
8. Press the or arrow to select the week (1st, 2nd, etc.) Daylight Saving Time ends, then press ENTER to
make your selection and move to the month setting.
9. Press the or arrow to select the month (January – December) Daylight Saving Time ends, then press
ENTER two times to make your selection and exit.