SilentKnight 5700 - Manual (Page 120)

Programming 151295
7-22
each field.
Figure 7-13 Reporting Account Editing Screen
Select Account (ID)
The control panel provides up to 4 reporting accounts. The priority of an account is based on its account ID.
Account 1 is highest priority; Account 4 is lowest. Use Account 1 to report the highest priority events.
6. Press the or arrow to select account ID number, then press ENTER .
Edit Account Number
Enter an up-to-6-digit number for each account to identify the account to the central station. See Figure 7-13 for
location of this option on the screen. The account number should be compatible with the reporting format used.
For example, the Contact ID format transmits up to four digits only.
7. Enter the desired account number (up to 6-digits), then press ENTER .
Select Reporting Format
Select a reporting format for each account. Options are:
8. Press the or arrow to select the reporting format, then press ENTER .
Events to Report
The next five options select which types of events (or event families) will be reported to this account. (See Figure
7-13 for location of these options on the screen).
9. Press the or arrow to select Must, Yes, or No (see Table below), then press ENTER .
SIA SIA format. 8 events per call.
CID Ademco’s Contact ID format
S20 Same as SIA reports up to 20 events per phone call.
Event Family Events Included in this Family
Alarms All alarms (Water Flow, Manual Pull, Detectors, Auxiliary Switches, etc.)
Alarm Restore All alarm restores.
Supervisory, Trouble, Enable/
Disable Point All trouble and supervisory conditions and trouble and supervisory restores.
Enabling and disabling of input and output points.
Service/Test Fire drill, walk test, dialer test, automatic test, all programming sessions.
System Reset All system resets.