beautypg.com

Cleaning the keyboard – Juniper Systems Allegro DOS Manual User Manual

Page 30

background image

Page 2-12 Hardware Features

Cleaning the Keyboard

Dirt and debris can get underneath the keyboard bezel. To clean it, use a
coin to pull the bezel up at the recess located at the bottom of the
keyboard and remove it. We recommend that you use warm water, mild
detergent, and a toothbrush to clean the keyboard or simply brush it
out. The Allegro remains sealed during this process. (Do not direct a
high pressure stream of water at the keyboard to clean it. This action
could break the seal, causing water to get inside the Allegro.)

Reattach the bezel by carefully inserting the top ridge under the
function keys and lowering the bezel down flat onto the case. Press
down along the sides while aligning the keys through the holes.

Important Note: After you reattach the bezel, check each key to make sure it
is completely free from the bezel. If any part of a key is caught underneath the
bezel, you may not be able to turn the Allegro on or you may hear a continuous
string of beeps.