Uploading socketserver with portvision dx, Uploading socketserver with, Portvision dx – Comtrol Hub DeviceMaster User Manual
Page 45
DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
Initial Configuration - 45
Uploading SocketServer with PortVision DX
Uploading SocketServer with PortVision DX
Use this section to upload a newer version of
on the DeviceMaster
using PortVision DX. Technical Support recommends updating SocketServer
before any further configuration to avoid configuration problems.
You can use this procedure if your DeviceMaster is connected to the host PC,
laptop, or if the DeviceMaster resides on the local network segment.
1.
Make sure that you have downloaded the latest SocketServer version from:
ftp://ftp.comtrol.com/dev_mstr/rts/software/socketserver
.
2.
If necessary, open PortVision DX > Start/Programs > Comtrol > PortVision DX >
PortVision DX or use the desktop shortcut.
3.
Right-click the DeviceMaster or DeviceMasters for which you want to update,
click Advanced > Upload Firmware, browse to the SocketServer .cmtl file, and
then click Open.
If the Detection Type is set to REMOTE, you may want to change it to LOCAL.
The DeviceMaster Status on a DeviceMaster that is set to REMOTE displays
in blue:
ON-LINE (TCP)
.
Optionally, you can highlight the DeviceMaster and
click the Upload button in the Launch bar.