Comtrol Hub DeviceMaster - Manual (Page 15)

DeviceMaster Installation and Configuration Guide: 2000594 Rev. A Hardware Installation - 15
Hardware Installation
Installation Overview
Use the links below to locate installation procedures for the following models:
Note: The DeviceMaster LT provides different RJ45 pin outs and is not discussed
in this guide. Refer to the DeviceMaster LT User Guide for product-specific
information.
DeviceMaster PRO
DB9 serial ports with dual
Ethernet†† ports
8† 4-Port and 8-Port Installation on Page 26
RJ45 serial ports with dual
Ethernet†† ports
16
16-Port (DeviceMaster PRO) Installation on
Page 30
DeviceMaster RTS
DB9 serial port with a
single Ethernet port
1 1-Port - Enclosed Installation on Page 16
Embedded system 1 1-Port - Embedded Installation on Page 18
Screw terminal serial ports 2‡
2-Port (Serial Terminal) 1E/2E Installation
on Page 22
DB9 serial ports 2‡ 2-Port (DB9) 1E/2E Installation on Page 24
DB9 serial ports with dual
Ethernet†† ports 4† or
8†
4-Port and 8-Port Installation on Page 26
RJ45 serial ports with dual
Ethernet†† ports
16
16-Port (DeviceMaster RTS - External Power
Supply) Installation
on Page 28
RJ45 serial ports with a
single Ethernet port 16 or
32 16/32-Port Rack Mount Models (Internal
Power Supply) Installation
on Page 32
DeviceMaster Serial Hub
DB9 serial ports with dual
Ethernet†† ports
8 4-Port and 8-Port Installation on Page 26
DB9 serial ports with a
single Ethernet port
16
16/32-Port Rack Mount Models (Internal
Power Supply) Installation
on Page 32
† The DeviceMaster RTS 4 and 8-port models may also include DB9 to RJ45
adapters.
†† One of the Ethernet ports on the DeviceMaster is a built-in downstream port
for daisy-chaining DeviceMaster systems or other network-ready devices.
‡ Either Ethernet port on the DeviceMaster RTS 2-port 2E model can be used
for daisy-chaining DeviceMaster systems or other network-ready devices.
Default Network Settings
IP address:
192.168.250.250
Subnet mask:
255.255.0.0
Gateway address:
192.168.250.1