Comtrol Hub DeviceMaster User Manual
Page 33
DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
Hardware Installation - 33
Hardware Installation
2.
Connect the DeviceMaster port labeled 10/100 NETWORK to the same
Ethernet network segment as the host PC using a standard network cable.
If you plan on using the NS-Link device driver, make sure that you do
not connect RS-422/485 devices until the appropriate port interface
type has been configured in the driver. The NS-Link default port
setting is RS-232.
3.
Apply power to the DeviceMaster by connecting the appropriate power cord
into the power socket on the DeviceMaster, plugging the power cord into a
power source, and turning on the power switch.
4.
Verify that the Status LED has completed the boot cycle and network
connection for the DeviceMaster is functioning properly using the table below.
5.
Go to
on Page 35 for default network settings and how to
configure the DeviceMaster for use.
DeviceMaster RTS - Larger pictures,
DeviceMaster Serial Hub - Larger picture,
Caution
16/32-Port (Internal Power Supply) LED Descriptions
Status
The amber Status LED on the device is lit, indicating you have power
and it has completed the boot cycle.
Note: The Status LED flashes while booting and it takes approximately
15 seconds for the Bootloader to complete the cycle. When the
Bootloader completes the cycle, the LED has a solid, steady light
that blinks approximately every 10 seconds. For additional LED
information, go to the
LNK/
ACT
The red LNK/ACT LED is lit, indicating that you
have a working Ethernet connection.
Duplex
If the red Duplex LED is lit, it indicates full-duplex
activity.
100
If the red 100 LED is lit, it indicates a working 100
MB Ethernet connection (100 MB network, only). If
the LED is not lit, it indicates a 10 MB Ethernet
connection.
Note: The port LED activity may be inconsistent until the port has been opened.
After a port is opened, LED activity works as documented.
LNK/
ACT
Duplex
100
10/100 ETHERNET