Comtrol Hub DeviceMaster User Manual
Page 164
164 - Troubleshooting and Technical Support
DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
Troubleshooting and Technical Support
9.
Verify that the port has been enabled.
10. Leave the web page open.
11. Attach the loopback plug that was shipped with the DeviceMaster to the serial
port of the DeviceMaster. See
on Page 91 if you need
to build a loopback plug.
12. Right-click the DeviceMaster in the Device List pane and click Telnet / SSH
Session.
13. Enter the socket number of the port that you are testing (
) and click Ok.
This manual is related to the following products: