Ns-link com port, Socket port, Ns-link com port socket port – Comtrol Hub DeviceMaster User Manual
Page 120
120 - Managing the DeviceMaster
DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
Managing the DeviceMaster
NS-Link COM Port
You can use this procedure to reset NS-Link serial port settings.
1.
Open the Comtrol Drivers Management Console using Start > Programs >
Comtrol > DeviceMaster or under Control Panel, Comtrol Drivers Management
Console.
2.
Highlight the first port that you want reset to default values.
3.
Click the Defaults button (and if appropriate, Clone).
4.
Click Apply or Ok.
If necessary, you can reset DeviceMaster device properties to their defaults on the
Device General tab using the Defaults button.
Socket Port
Use the following procedure to reset the socket port serial settings.
1.
Open the DeviceMaster web page (
Accessing Socket Configuration
2.
Scroll to the bottom of the Server Status page (main) and click Reboot.
3.
When the Reboot page appears, click the Set configuration for all ports to factory
default settings check box.
4.
Click the Yes, Reboot button.