Comtrol Hub DeviceMaster - Manual (Page 43)

DeviceMaster Installation and Configuration Guide: 2000594 Rev. A Initial Configuration - 43
Checking the SocketServer Version
12. Click Apply Changes to update the network information on the DeviceMaster.
Note: If you are deploying multiple DeviceMasters that share common values,
you can save the configuration file and load that configuration onto
other DeviceMasters. See
Using SocketServer Configuration Files on
Page 107 for more information.
13. Click Close to exit the Properties window.
14. Go to Checking the SocketServer Version on Page 43 to check the SocketServer
version. You should update SocketServer firmware before any further
configuration.
Checking the SocketServer Version
SocketServer refers to the web page that is integrated in the firmware that comes
pre-installed on your DeviceMaster platform, which provides an interface to TCP/
IP socket mode configuration and services. If you install an NS-Link device driver,
an NS-Link version of SocketServer loads on the DeviceMaster.
Note: Technical Support recommends that you update to the latest version of
SocketServer before installing an NS-Link device driver or configuring
socket ports.
Use the following procedure to check the SocketServer version on the
DeviceMaster and check the ftp site for the latest version.
1. If necessary, open PortVision DX > Start/Programs > Comtrol > PortVision DX >
PortVision DX or use the desktop shortcut and scan the network.
2. Check the SocketServer version number of the Software Version for the
DeviceMaster.