Comtrol Hub DeviceMaster - Manual (Page 102)

102 - Connecting Serial Devices DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
Connecting Serial Devices
Connecting Serial
Devices Use the following information to connect the DeviceMaster 2-port 2E with serial
terminals.
1. Connect your serial devices to the appropriate serial port on the DeviceMaster
using the appropriate cable.
Note: Refer to the hardware manufacturer’s installation documentation if you
need help with connector pinouts or cabling for the serial device.
2. You can refer to Network and Device LEDs on Page 169 for information about
the LEDs.