Comtrol Hub DeviceMaster - Manual (Page 162)

162 - Troubleshooting and Technical Support DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
Troubleshooting and Technical Support
Socket Mode Serial Port Testing
This procedure illustrates using Putty, which is available in PortVision DX.
Optionally, you can use any other Winsock compatible application.
Note: The following procedure starts with resetting DeviceMaster to factory
default values. You may want to save the DeviceMaster socket configuration
using
Saving a SocketServer Configuration File on Page 107.
1. If necessary, install PortVision DX using Installing PortVision DX on Page 37
and scan the network to locate the DeviceMaster that you want to test.
2. Right-click the DeviceMaster and click Webpage.
3. Scroll to the bottom of the home page and click Reboot.
4. Click the Set configuration for all ports to factory default settings option and then
click the Yes Reboot button.