Comtrol Hub DeviceMaster - Manual (Page 134)

134 - RedBoot Procedures DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
RedBoot Procedures
Resetting the DeviceMaster
When you have completed your tasks in RedBoot, you must enter a reset command
at the RedBoot> prompt for the DeviceMaster to begin operation.
Note: The LEDs on the DeviceMaster will go through the power up sequence. The
DeviceMaster has completed its reset cycle when the PWR or Status LED is
lit and it stops flashing.
Configuring Passwords
This section discusses how to configure a password for the web and telnet server.
Note: See the PortVision DX or SocketServer Help system for information about
email notification.
Use the following procedure to establish the DeviceMaster password for the Web
and telnet server. Establishing a password prevents unauthorized changes to the
DeviceMaster configuration.
1. Establish communications with the DeviceMaster using the serial (Page 130)
or telnet method (Page 131).
2. Type password [your_password] and press Enter.
Note: If you forget your password, you can reprogram the password using the
serial method which bypasses the password.
Note: The Bootloader version on your DeviceMaster may be different than the
version displayed in this graphic.
See the auth command in the RedBoot Command Overview on Page 135, if you
want to set up Web browser authentication.
RedBoot> dis
Loading disabled
RedBoot> reset
Password:
*********************************************
**
** Comtrol DeviceMaster Bootloader Version 3.23
** RedBoot(tm) environment - built 14:59:20, Oct 13 2011
** Platform: Comtrol DeviceMaster (ARM 7TDMI)
** Portions Copyright (C) 2000. Red Hat, Inc.
** Portions Copyright (C) 2001-2008 Comtrol Corp.
*********************************************
FLASH: 64 blocks of 65536 bytes each
FLASH: 4194304 bytes (0x05000000 - 0x05400000)
RAM: 8126464 bytes (0x00000000 - 0x007c0000)
RedBoot> dis
Loading disabled
RedBoot> password dev1357
Password ‘dev1357’
RedBoot
>