O to, Step 4, To v – Comtrol Hub DeviceMaster User Manual
Page 17
DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
Hardware Installation - 17
Hardware Installation
•
Insert the DC positive wire into the
positive screw terminal and the DC
return wire into the return screw
terminal.
If you purchased the Comtrol power
supply (separately), the wires are
identified below:
-
Red = 5-30VDC positive
-
White = 5-30VDC return
-
Black = earth ground
If you did not purchase a power supply
from Comtrol for the DeviceMaster, see
•
Use a small flat head screw to lock the wires into place.
•
Verify that each wire has been tightened securely.
•
Plug the screw terminal power connector into the
DeviceMaster.
Note: Align the plug properly. The scalloped side of
the screw terminal power connector should be
aligned with the scalloped side of the power
jack on the unit.
•
Connect the power supply to a power source.
•
Go to
to verify that the DeviceMaster is
functioning properly.
4.
Verify that the Status LED has completed the boot cycle
and network connection for the DeviceMaster is functioning properly using the
table below.
5.
Go to
on Page 35 for default network settings and how to
configure the DeviceMaster for use.
1-Port Enclosed LED Descriptions
Status
The amber Status LED on the device is lit, indicating you have power
and it has completed the boot cycle.
Note: The Status LED flashes while booting and it takes
approximately 15 seconds for the Bootloader to complete the
cycle. When the Bootloader completes the cycle, the LED has a
solid, steady light that blinks approximately every 10 seconds.
Link/Act
If the red Link/Act LED is lit, it indicates a working Ethernet
connection.
Duplex
If the red Duplex LED is lit, it indicates full-duplex activity.
100
If the red 100 LED is lit, it indicates a working 100 MB Ethernet
connection (100 MB network, only). If the LED is not lit, it indicates
a 10 MB Ethernet connection.
Note: For additional LED information, go to the
Earth Gnd
Return
Positive
5-30VDC
+
-
Wire gauge:
AWG 12-22
Screw Terminal Power Connector