KEYENCE CV-H5N - Manual (Page 91)

4
CV-H5N-M-WW-NO4-E 4-7
2
Click the [General] tab, then change the settings to
match the configuration of the CV-5001 Series controller
and computer.
Connection point settings
Note
If the " Delimiter " field is changed after communication has begun, the software will need to be restarted. The change in the
" Delimiter " field will not be affected until the software is restarted.
Category Item Contents Setting Range
Sensor Connection Point
Name Sets the name of the connection point. Up to 32 characters
(default: 192.168.0.10)
CV model Selects the CV-5001 Series controller to be
connected. CV5000 (Fixed)
LAN Used when the CV-5001 Series controller and the computer are connected via Ethernet.
Network Sets the LAN card of the computer used to
connect to the network. Note
Only available when connecting to
the software via Ethernet.
CV IP address Sets the IP address for the CV-5001 Series
controller. 0.0.0.0 to 255.255.255.255
(default: 192.168.0.10)
Delimiter Sets the code used for the end or
transmission of blocks of character data. CR (default) / CR + LF
Data port Sets the port number used for result data
output from the CV-5001 Series controller. (default: 8500)
Image port Sets the port number used for image data
output from the CV-5001 Series controller. (default: 8501)
COM Used when the CV-5001 Series controller and the computer are connected via USB or serial interface (RS-232C).
USB Port Selects a valid COM port. Note
Only available when connecting to
the software via USB.
Delimiter Sets the code used for the end or
transmission of blocks of character data. CR (default) / CR + LF
RS-232C Port Selects a valid COM port. Note
Only available when connecting to
the software via a serial connection.
Baud Selects the communication speed. 9600 (default) / 19200 / 34800 /
57600 / 115200
Stop bit Selects the stop bit. 1 (default) / 2
Parity bit Selects the parity bit. None (default) / odd / even
Flow control Selects the flow control. None (default) / RTS/CTS / xon/xoff
Delimiter Selects the delimiter. CR (default) / CR + LF
Data size Selects the data length. 7 / 8 (default)