KEYENCE CV-H5N - Manual (Page 79)

3
CV-H5N-M-WW-NO3-E 3-15
Obtaining CV-5001 Series Controller Output Configuration Data from a Computer
This software allows you to load information from a CV-5001 Series controller to a computer via an Ethernet (1-to-1
or LAN), USB or RS-232 connection.
1
Select [Acquire output setup data] under [(connection
name)] from the [Connections] menu.
The [Acquire output setup data] confirmation message will
appear and the output configuration data will be loaded
from the CV-5001 Series controller.
2
The [Acquire output setup data] confirmation message
will appear. A short while later, a message saying
"Output setup data has been acquired. " will appear.
Click the [OK] button.
■ Troubleshooting
Check the following issues if you are unable to load data from the CV-5001 Series controller.
• Is the Ethernet, USB or RS-232C cable properly plugged into the socket? Check that the cable is properly
connected.
Refer to "CV-5001 Series User’s Manual" (page 9-1).
• If using an Ethernet connection, are the network settings on the CV-5001 Series controller and the computer
set properly?
Refer to the CV-5001 Series controller manual and make sure that the network settings are correct.
Refer to "CV-5001 Series User’s Manual" (page 9-3).
• Is the output data set to be output?
Refer to the CV-5001 Series controller manual and make sure that the output settings are correct.
Refer to "CV-5001 Series User’s Manual" (page 4-162).
1
2