KEYENCE CV-H5N - Manual (Page 171)

CV-H5N-M-WW-NOA-E A-3
A
When software is in
use An error has occurred.
Reinstallation of the
software is required. – The installation has not
been successfully
completed.
The necessary software
has been removed. Reinstall the software.
Simulator
Loading image data Unable to load image
data. – The controller is not in the
"RUN" state.
The Ethernet, RS-232C or
USB cable is not
connected correctly. Set the controller to the
"RUN" state.
Check the Ethernet, RS-
232C or USB cable
connection.
BR command has
returned an error. – This is normal operation.
There is no problem. This is normal operation.
There is no problem.
Simulator program
data management
Writing into a CV Unable to write to
xxx\c\cv\setting\zzz\cvset.
dat. xxx = (folder on
simulator virtual C
drive)
zzz = (write target
program number) Program data cvset.dat
does not exist for that
target program number. Select a program for which
there is program data.
Simulator global
settings management
Writing into a CV Unable to load global
settings. – No global settings exist for
that virtual CV. Select a virtual CV for
which there are global
settings.
Simulator
Inputting a serial key The serial key was not
input correctly. – The serial key is incorrect. Enter the correct serial key.
Refer to "Obtaining a
Serial Key for the Simulator"
(page 1-12) for more
information on serial keys.
Starting the simulator The hardware
configuration has
changed since
installation. Please
reinstall the software
before proceeding. – The hardware
configuration has changed
since installation. Either reinstall the software
and obtain a new serial key
or reset the configuration of
the hardware to the
configuration at the time of
install.
Using the software An error has occurred.
Please reinstall the
software. – Unable to complete
installation.
Necessary software has
been deleted. Reinstall the software.
Starting the software Microsoft .Net Framework
Ver. 1.1 is required to run
this application. Run the
application again after
installing this software. – Microsoft .Net Framework
Ver. 1.1 has not been
installed. Reinstall the software.
Item Message Detailed contents (***) Cause Resolution