KEYENCE CV-H5N User Manual

Page 78

CV-H5N-M-WW-NO3-E

3-14

■ Specifying a connection point

Set the connection point so that the CV-5001 controller can be recognized by this software.

Select [New connection] from the [Connections] menu.

The [Edit Connection Setting] window appears.

[Edit Connection Setting] window

Click the [General] tab, then set the RS-232 parameters

of the CV-5001 Series controller to be connected.

Turn [COM] and [RS-232C] on, then set the connection

name and RS-232C communication protocol.

The following settings are used here as an example.

1. Connection point name: Connection point 1

2. Image sensor type: CV5000

3. Port: Communication port (COM1)

4. Communication speed: 115200

5. Stop bit: 1

6. Parity: None

7. Flow control: None

8. Delimiter: CR

9. Data length: 8

Reference

The connection name is the number used to distinguish between

controllers when multiple CV-5001 Series controllers are

connected.

CV-5001 Series
[PLC - EIP - RS-232C] settings screen

Set [PLC - EIP - RS-232C] under [Global] on the CV-5001
Series controller, as shown to the left.

Click the [OK] button when settings are finished.

The connection point is added.

Note

•

First set the CV-5001 Series controller to [Run] mode. A proper

connection cannot be made in [Prog.] mode.

•

There is a chance that data will be lost when storing image data.

■ Obtaining CV-5001 Series controller output configuration data

Obtain the output settings from the CV-5001 Series controller so that the software can recognize those settings.