KEYENCE CV-H5N - Manual (Page 73)

3
CV-H5N-M-WW-NO3-E 3-9
3
Click the [OK] button when settings are finished.
The connection point is added.
Note
First set the CV-5001 Series controller to [Run] mode. A proper
connection cannot be made in [Prog.] mode.
■ Obtaining CV-5001 Series controller output configuration data
Obtain the output settings from the CV-5001 Series controller so that the software can recognize those settings.
Refer to "Obtaining CV-5001 Series Controller Output Configuration Data from a Computer" (page 3-15) for more
information.
Settings for a LAN Ethernet Connection
■ Setting up a LAN Ethernet connection
The CV-5001 Series controller can be connected to a computer over the Local Area Network using standard
Ethernet LAN (straight) cables. Ethernet LAN connections will vary with the environment of the LAN they are
connected to. This section uses the example of connecting to a hub.
Note
Refer to the CV-5001 Series controller manual for more information on CV-5001 Series controller network connection settings.
■ Computer settings before connection
Use the settings listed before for the TCP/IP properties.
This normally means turning on "Obtain an IP address automatically" under "Internet Protocol (TCP/IP)".
Note
Talk to your network administrator for details.
■ Connecting a CV-5001 Series controller
1
Connect the CV-5001 Series controller Ethernet port to
the Ethernet cable (commercial straight cable).
2
Connect the Ethernet cable (commercial straight cable)
to the hub.