KEYENCE CV-H5N - Manual (Page 161)

4
CV-H5N-M-WW-NO4-E 4-77
Communication Command Monitor
This section explains how to send and receive individual communication commands from a connected CV-5001 controller.
1
Select [Communication terminal] from the Tools menu.
The [Communication terminal] menu appears.
Set each item, then confirm the communication state.
Note
If receiving image data over a T1, the monitor will display "output
data, image data, reception confirmation message".
[Communication terminal] menu
1 Monitor area
Displays the contents of all communications sent and received.
Reference
When saving and printing the communications command monitor results, drag the communication results to the monitor area,
then right click and select "copy". This will allow you to paste them into other software applications.
2 Command
Enter a command to send from the computer. Click the [Send] button to send the command. Click the [Clear log] button to clear the monitor area.
Reference
Refer to "CV-5001 Series User’s Manual" (page 9-10) for a list of communication commands.
3 Connection name
Select a Connection Point
Click the [Connect] button to connect to the selected connection point.
Click the [Disconnect] button to disconnect from the selected
connection point.
Click the [Edit settings] button to change the settings of the connection
point selected under [Connection name].
4 File to send
First load the binary data you wish to use, then send it from the
computer.
5 Save folder
Select the folder to save binary data sent from the computer.
1
1
2
3
4
5