KEYENCE CV-H5N - Manual (Page 45)

2
CV-H5N-M-WW-NO2-E 2-21
3
Press the execute button to read the specified program
data and recorded images in that order.
4
Start the simulator.
Select [Start simulation] from the [Simulator] menu.
Once the simulator has started, changing the target
Program no. to the read target selected in step 2 allows you
to confirm the program contents.
2. Write the program from the connected CV-5001 series
Change the program set in step 1 with the simulator, then write it to the device.
1
Close the simulator.
2
Write the programs and recorded images to the CV.
Select the [Write to cv] tab from [Transfer programs] from the
[Simulator] menu.
Specify [Write from] or [Write to], then press the execute
button.
The begin writing confirmation will appear. Select "Yes" to
start writing.
Note
During writing, there is a timing where the Ready terminal on the
controller will be off and trigger input is disabled. Additionally, after
writing to [Current program] or [Program no. currently in use], the
changes will be reflected after a reset.
Set the Program no. to be written from the computer.
Set the read and write targets on
the connected controller.