KEYENCE CV-H5N - Manual (Page 74)

3
CV-H5N-M-WW-NO3-E 3-10
■ Specifying a connection point
Set the connection point so that the CV-5001 Series controller can be recognized by this software.
Use the settings from the "New Connection" window, as before.
Note
• Talk with your network administrator before assigning an IP address to a connection point.
• On Windows Vista/7, the connection point cannot be set if the Ethernet cable is disconnected.
• When this software is used in combination with an Ethernet PLC link communication, data may not be saved due to the high
load on the CV-5001 controller.
■ Obtaining CV-5001 Series controller output configuration data
Obtain the output settings from the CV-5001 Series controller so that the software can recognize those settings.
Refer to "Obtaining CV-5001 Series Controller Output Configuration Data from a Computer" (page 3-15) for more
information.
Connecting via USB
■ If this is the first time you are using this software:
1
Connect the CV-5001 Series controller to the computer
with a USB cable (OP-66844 (Optional)).
The “Hardware Update Wizard” appears on the computer
screen.
2
Select “Install from a list or specific location”, then
specify the folder containing the USB driver.
USB driver installation will begin.
Reference
• The USB driver can be found on the included CD-ROM or in
“\driver\usb\win32\(32bit) or \driver\usb\win64\(64bit)” in the
download file.
• When installing the driver on a computer running Windows XP or
Vista or 7, an alarm screen may appear during installation. When
an alarm screen appears, select “Continue” to continue with
installation.