KEYENCE CV-H5N - Manual (Page 76)

3
CV-H5N-M-WW-NO3-E 3-12
■ Specifying a connection point
Set the connection point so that the CV-5001 Series controller can be recognized by this software.
1
Select [New connection] from the [Connections] menu.
The [Edit Connection Setting] window appears.
[Edit Connection Setting] window
2
Click the [General] tab, then set the USB parameters of
the CV-5001 Series controller to be connected.
Turn [COM] and [USB] on, then set the connection point
name and port number.
The following settings are used as an example here.
1. Connection name: Connection point 1
2. Image sensor type: CV5000
3. Port: USB Com Port Driver (COM3)
4. Delimiter: CR
Reference
• The connection name is used to distinguish between devices
when multiple CV-5001 Series controllers are connected.
• "3. Port” varies depending on the computer.
CV-5001 Series
[USB] settings screen
Set the USB parameters in the [USB] menu under [Global]
on the CV-5001 Series controller as shown to the left.
3
Click the [OK] button when settings are finished.
The connection point is added.
Note
First set the CV-5001 Series controller to [Run] mode. A proper
connection cannot be made in [Prog.] mode.
■ Obtaining CV-5001 Series controller output configuration data
Obtain the output settings from the CV-5001 Series controller so that the software can recognize those settings.
Refer to "Obtaining CV-5001 Series Controller Output Configuration Data from a Computer" (page 3-15) for more
information.
2
3