KEYENCE CV-H5N - Manual (Page 72)

3
CV-H5N-M-WW-NO3-E 3-8
■ Connecting a CV-5001 Series controller
1
Connect the CV-5001 Series controller Ethernet port to
the Ethernet cable (cross cable: OP-66843).
2
Connect the computer Ethernet port to the Ethernet cable
(cross cable: OP-66843).
■ Specifying a connection point
Set the connection point so that the CV-5001 device can be recognized by the software.
1
Select [New connection] from the [Connections] menu.
The [Edit Connection Setting] window appears.
[Edit Connection Setting] window
2
Set the network information of the CV-5001 Series
controller to be connected on the [General] tab.
Click on [LAN], then set the connection point name and IP
address (same as connected CV-5001 Series controller).
The following settings are used as an example here.
1.
Connection name: Connection point 1
2. Image sensor type: CV5000
3. Connection point IP address: 192.168.0.10
4. Delimiter: CR
5. Data port number: 8500
6. Image output port number: 8501
Reference
The connection name is used to distinguish between devices when
multiple CV-5001 Series controllers are connected.
CV-5001 Series
[Ethernet] setting screen
Note
Set the Ethernet parameters in the [Ethernet] menu under [Global]
on the CV-5001 Series controller as shown to the left.
Note
Be sure that there are no errors in the IP address.
Refer to "Specifying a New Connection Point" (page 4-6) for
more information.
2
3