D connecting the c-96 autosampler to ngc systems, Using the c-96 autosampler with ngc systems, Connecting the c-96 autosampler to an ngc system – Bio-Rad ChromLab™ Software User Manual
Page 291: Appendix d, Connecting the c-96 autosampler to, Ngc systems, Connecting the c-96 autosampler to ngc systems, Using the, C-96 autosampler with, Systems
Instrument Guide
| 289
D
Connecting the C-96
Autosampler to NGC Systems
Using the
C-96 Autosampler with
NGC
Systems
The C-96 autosampler enhances NGC™ chromatography systems, providing
automated, accurate, and reproducible sample injections. Its easy-to-install
accessories allow for a wide range of injection volumes from 5 μl–10 ml.
The signal import module (SIM) connects the C-96 autosampler to NGC systems.
The SIM digitizes the analog signal from the C-96 autosampler and transmits the
signal to the NGC system.
This appendix explains how to connect and set up the C-96 autosampler for use
with the NGC instrument.
Tip:
To install and set up the C-96 autosampler, see its documentation.
Connecting the C-96 Autosampler to an NGC System
To connect the autosampler to an NGC system
1.
Ensure that both the NGC instrument and the C-96 autosampler are powered
off.
2.
Connect the SIM device to the NGC instrument. See
for more information.
3.
On the back of the SIM, firmly grasp the DIGITAL IN female connector and pull
it straight out of its port.
4.
Grasp the DIGITAL OUT male connector and pull it out of its port.