Bio-Rad ChromLab™ Software - Manual (Page 231)

Other Components
Instrument Guide | 229
8. The frame of the bay has tracks on the top and bottom of the right side. The
module has guide rails on the top and bottom right side.
Align the rails on the module with the tracks in the bay to properly guide it into
position.
9. Place the module into the open bay and gently push it in as far as it will go.
Note: Each module has an alignment pin on the back to ensure that it
aligns correctly with the main communication board.
10. Ensure that the screw holes on the module align with the screw holes on the
bay.
11. Insert the screws that shipped with the module into the screw holes.
12. Tighten the screws to secure the module.
Bottom of Module Top of Module