Bird Technologies SA-6000EX - Manual (Page 47)

Measure Match Mode
31
Measure the Match of the Component
1. Connect the Site Analyzer to the component being tested as follows:
•
ANTENNA – (if used) Connect the Phase Stable Cable directly
to the coaxial connector of the antenna. There should be no
other transmission lines or jumpers connected.
•
OTHER COMPONENTS – (Including Jumpers, Transmission
Lines, Lightning Protectors, and RF Filters) Connect the
Phase Stable Cable to one end of the component. Connect the
Calibration Combination Load to the other end of the compo-
nent.
2. Wait at least 10 seconds for the sweep to update.
3. When you have a trace on the screen, you can do any of the
following:
•
Hold the trace (refer to Measurement Hold, page 33)
•
Add markers to the trace (refer to Markers, page 70)
•
Save the trace (refer to Save Trace, page 80)
•
Print the trace (refer to Printing, page 77)