Bird Technologies SA-6000EX User Manual
Site analyzer
SITE ANALYZER™
CABLE AND ANTENNA TESTER
FOR WIRELESS SYSTEMS
OPERATING INSTRUCTIONS
FOR MODELS
SA-1700EX, SA-1700EXP
SA-2500EX, SA-6000EX
©Copyright 2008 by Bird Electronic Corporation
Instruction Book Part Number 920-7002A600S Rev. J
Site Analyzer is a trademark of Bird Electronic Corporation
Microsoft® and Windows® are registered trademarks
of the Microsoft Corporation
This manual is related to the following products:
Table of contents
Document Outline
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Calibration
- Chapter 3 Measure Match Mode
- Determine the Power of the Component Being Tested
- Select the Measure Match Mode
- Setting the Measurement Frequency
- Calibrate the Site Analyzer
- Select the Measurement Units
- Set the Measurement Scale Limits
- Set the Measurement Data Points
- Set the Graph Display Type
- Set and Activate Acceptance Limits
- Measure the Match of the Component
- Interpreting the Measurement
- Measurement Hold
- Markers
- Printing
- Cable Loss Measurement
- Interpreting the Cable Loss Measurement
- Chapter 4 Fault Location Mode
- Determine the Power of the Component Being Tested
- Select Fault Location Mode
- What You Need to Know About Setting the Frequency Span and Max Distance
- Setting the Frequency Span
- Setting the Maximum Distance
- Calibrate the Site Analyzer
- Setting the Cable Type
- Setting the Distance and Units
- Setting the Scale & Unit of Measure
- Set the Measurement Data Points
- Set the Graph Display Type
- Set and Activate Acceptance Limits
- Test for Fault Location
- Interpreting the Fault Location Measurement
- Measurement Hold
- Markers
- Smooth
- Saving The Measurement
- Printing
- Chapter 5 Save and Recall
- Chapter 6 Measure Power Mode
- Chapter 7 Utilities
- Chapter 8 Computer Software
- Chapter 9 Maintenance