Set and activate acceptance limits – Bird Technologies SA-6000EX User Manual
Page 45

Measure Match Mode
29
Set and Activate Acceptance Limits
The limit line helps you see failures. It appears as a horizontal line at
the value you select.
You can set an acceptance limit line to help visualize what part of the
measurement trace is not acceptable. The part of the trace that is not
acceptable will display in red. To view the limit line, you must have
the limit test ON. This feature is available only in the Measure Match
mode and the Fault Location mode.
1. Turn on the instrument and enter the Measure Match mode (refer
to Select the Measure Match Mode, page 18).
2. Select the frequency (refer to Setting the Measurement
3. Calibrate the unit (refer to Calibrate the Site Analyzer, page 21).
4. Follow the numbered steps in Figure 10, page 30 to turn ON the
limit test and set the limit line value.
Note:
You can set a limit line value with the limit test
turned OFF, but you will not see a line displayed on the screen.