Pflex-in006c-en-p, october 2004 – Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives User Manual
Page 211
Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013
211
History of Changes
Appendix F
PFLEX-IN006C-EN-P,
October 2004
Change
Updated the drive ratings for PowerFlex 700H and 700S
Updated the information on installing unbalanced, ungrounded or resistive grounded distribution systems
Added information on DC input precharge control wiring
Updated the “Control Board Slot Designations” table for the new 20C-DG1 digital I/O option board
Added drive catalog numbers for 700H control I/O board options
Updated the “Analog Input, PTC 0-10V Input” wiring example
Added Chapter 4, “Control Wiring for PowerFlex 700S Drives with Series II Control”
Updated information on frame 9 operating temperatures
Updated frame 9 installation instructions for unbalanced, ungrounded or resistive grounded distribution systems
Updated frame 10 minimum mounting clearances
Updated frame 10 operating temperatures
Added dimensions drawing for frame 10 NEMA/UL Type 12 - IP54 Enclosure
Updated frame 10 “Moving Control Frame” to show slotted holes in Control Frame
Updated frame 10 “Removing Protective Covers” to omit screws that were not present.
Updated frame 10 installation instructions for unbalanced, ungrounded or resistive grounded distribution systems
Updated frame 11 minimum mounting clearances
Updated frame 11 operating temperatures
Added dimensions drawing for frame 11 NEMA/UL Type 12 - IP54 Enclosure
Updated frame 11 installation instructions for unbalanced, ungrounded or resistive grounded distribution systems
Added Chapter 9, “Frame 12 Installation”
Added Chapter 10, “Frame 13 Installation”
Updated the agency certifications
Updated the drive protection specifications
Updated the fusing and circuit breaker specifications
Added specifications and wiring diagram for using the Stahltronic linear encoder