Rockwell Automation 2080-LC50 Micro830 and Micro850 Programmable Controllers User Manual - Manual (Page 57)

Rockwell Automation Publication 2080-UM002F-EN-E - December 2013 43
Communication Connections Chapter 5
The Micro800 controllers support the protocol through RS-232 connection to
external devices, such as computers running RSLinx Classic software, PanelView
Component terminals (firmware revisions 1.70 and above), or other controllers
that support CIP Serial over DF1 Full-Duplex, such as ControlLogix and
CompactLogix controllers that have embedded serial ports.
EtherNet/IP, supported on the Micro850 controller, makes use of the standard
Ethernet TCP/IP protocol. The Micro850 controller supports up to 16
simultaneous EtherNet/IP Server connections.
To configure CIP Serial, see Configure CIP Serial Driver on page 47 .
To configure for EtherNet/IP, see Configure Ethernet Settings on page 52 .
CIP Symbolic Addressing
Users may access any global variables through CIP Symbolic addressing except for
system and reserved variables.
One- or two-dimension arrays for simple data types are supported (for example,
ARRAY OF INT[1..10, 1..10]) are supported but arrays of arrays (for example,
ARRAY OF ARRAY) are not supported. Array of strings are also supported.
Supported Data Types in CIP Symbolic
Data Type (1)
(1) Logix MSG instruction can read/write SINT, INT, DINT, LINT and REAL datatypes using "CIP Data Table Read"
and "CIP Data Table Write" message types.
BOOL, USINT, UINT, UDINT, ULINT, LREAL, STRING and SHORT_STRING datatypes are not accessible with the
Logix MSG instruction.
Description
BOOL Logical Boolean with values TRUE and FALSE
SINT Signed 8-bit integer value
INT Signed 16-bit integer value
DINT Signed 32-bit integer value
LINT
(2)
(2) Not supported in PanelView Component.
Signed 64-bit integer value
USINT Unsigned 8-bit integer value
UINT Unsigned 16-bit integer value
UDINT Unsigned 32-bit integer value
ULINT
(2)
Unsigned 64-bit integer value
REAL 32-bit floating point value
LREAL
(2)
64-bit floating point value
STRING character string (1 byte per character)