beautypg.com

Rockwell Automation 2080-LC50 Micro830 and Micro850 Programmable Controllers User Manual User Manual

Page 252

background image

236

Rockwell Automation Publication 2080-UM002F-EN-E - December 2013

Appendix E Troubleshooting

0xF8A0

The TOW parameters are invalid.

Perform the following:

Correct the program to ensure that there are no invalid parameters.

Build and download the program using Connected Components Workbench.

Put the Micro800 controller into Run mode.

0xF8A1

The DOY parameters are invalid.

Perform the following:

Correct the program to ensure that there are no invalid parameters.

Build and download the program using Connected Components Workbench.

Put the Micro800 controller into Run mode.

0xFFzz
(Note: zz indicates
the last byte of the
program number.
Only program
numbers up to
0xFF can be
displayed. For
program numbers
01x00 to 0xFFFF,
only the last byte
is displayed.)

A user-created fault from Connected Components
Workbench has occurred.

Contact your local Rockwell Automation technical support representative if the
error persists.

List of Error Codes for Micro800 controllers

Error Code

Description

Recommended Action

This manual is related to the following products: