Debug a password-protected controller, Download to a password-protected controller – Rockwell Automation 2080-LC50 Micro830 and Micro850 Programmable Controllers User Manual User Manual
Page 163
Rockwell Automation Publication 2080-UM002F-EN-E - December 2013
147
Controller Security Chapter 9
Debug a Password-Protected Controller
To debug a locked controller, you have to connect to the controller through the
Connected Components Workbench software and provide the password before
you can proceed to debug.
1.
Launch the Connected Components Workbench software.
2.
On the Device Toolbox, expand Catalog by clicking the + sign.
3.
Select the catalog number of your controller.
4.
When requested, provide the controller password.
5.
Build and save your project.
6.
Debug.
Download to a Password-Protected Controller
1.
Launch the Connected Components Workbench software.
2.
Click Connect.
3.
Select the target controller.
4.
When requested, provide the controller password.
5.
Build and save the project, if needed.
6.
Click Download.
7.
Click Disconnect.
Transfer Controller Program and Password-Protect Receiving
Controller
In this scenario, the user needs to transfer user application from controller1
(locked) to another Micro800 controller with the same catalog number. The
transfer of the user application is done through the Connected Components
Workbench software by uploading from controller1, then changing the target
controller in the Micro800 project, and then downloading to controller2. Finally,
controller2 will be locked.
1.
On the Device Toolbox, open Discover and click Browse Connections.
2.
Select target controller1.
3.
When requested, enter the controller password for controller1.
4.
Build and save the project.
5.
Click Disconnect.
6.
Power down controller1.