Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual User Manual
Kinetix 350 single-axis ethernet/ip servo drives
Table of contents
Document Outline
- Kinetix 350 Single-axis EtherNet/IP Servo Drives User Manual, Pub 2097-UM002
- Summary of Changes
- Table of Contents
- Chapter 1 - Start
- Chapter 2 - Install the Kinetix 350 Drive System
- Chapter 3 - Kinetix 350 Drive Connector Data
- Chapter 4 - Connect the Kinetix 350 Drive System
- Basic Wiring Requirements
- Determine the Input Power Configuration
- Grounding Your Kinetix 350 Drive System
- Power Wiring Requirements
- Wiring Guidelines
- Wiring the Kinetix 350 Drive Connectors
- Apply the Motor Cable Shield Clamp
- Feedback and I/O Cable Connections
- Wiring the Feedback and I/O Connectors
- Shunt Resistor Connections
- Ethernet Cable Connections
- Chapter 5 - Configure and Start Up the Kinetix 350 Drive System
- Chapter 6 - Kinetix 350 Drive Safe Torque-off Feature
- Chapter 7 - Troubleshoot the Kinetix 350 Drive
- Appendix A - Interconnect Diagrams
- Appendix B - Upgrade the Kinetix 350 Drive Firmware
- Index
- Back Cover