Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 77)

Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Server Installation Procedures 3-11
18. At the Choose point mode acronyms window, click the Default
acronyms option and click Next.
19. At the Choose Fast History Rate window, choose a Fast History
collection rate and click Next. 5 seconds is the default rate.
20. Review the software installation details summarized in the Confirmation
window.
• If you need to make changes, click Back to access any previous
entries.
• If the details are okay, click Next to begin the Server setup. This may
take 10 to 15 minutes to complete.
21. If necessary, click OK at the Failed to uninstall Quick Builder setup
error.
22. Skip this step if the system does not include Excel Data Exchange.
Otherwise, click Enable Macros when prompted.
23. At the Setup Complete window, click the No, I will restart my computer
later option and click Finish.
24. Click Next to install the ProcessLogix Update.
25. At the ProcessLogix Update Complete window, click Finish.
TIP
To change the Fast History Collection Rate after
installation is complete, click Start
⇒
Programs
⇒
ProcessLogix Server
⇒
Setup.
TIP
If a Microsoft Excel dialog box appears, check the Do not
show this dialog again checkbox and click OK.
ATTENTION
! The CD must remain in the CD-ROM drive. You must
select No in Step 23.