Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 112)

Publication 1757-IN500A-EN-P - September 2002
4-24 ProcessLogix Server Upgrade Procedures
a. Click on the appropriate program in the list of installed programs.
b. Click Add/Remove, Change/Remove or Remove.
c. Click Yes to confirm removal.
d. Repeat the steps for each component in the following order.
Remove ProcessLogix Server Components
1. Click Start
⇒
Programs
⇒
ProcessLogix Server
⇒
Setup.
2. Click Next at the Welcome window.
3. Check the Remove ProcessLogix Server software checkbox and click
Next.
4. Click Select All and then click Next.
5. Click Yes to continue.
6. Click Next at the Confirmation window.
7. At the Setup Complete window, click the No, I will restart my
computer later option and click Finish.
IMPORTANT
Be sure to remove the components in the order they are
listed below.
Table 4.F Removal of Selected ProcessLogix R400.0 Components
✔
Order Component
1. ProcessLogix Update
2. Process Detail Displays (If you receive a Windows
Installer prompt, click Cancel, then click OK.
Continue with the next section.)