Importing the engineering database, Changing the default operator's password, Importing the engineering database -29 – Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide User Manual
Page 117: Changing the default operator's password -29
Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Server Upgrade Procedures 4-29
Importing the Engineering Database
Perform the steps below to import the Engineering Database. For a redundant
Server pair perform these steps on SERVERB only.
Changing the default Operator's password
In previous releases of ProcessLogix it was not necessary to change the default
mngr operator's password to use it. As a security precaution it is now necessary
to change the password before you can log in as the mngr operator. To change
the password, do the following:
1. Logon to R500.1 Server as ps_user.
2. Open Station.
3. Click the Oper field in the lower right corner of the display.
4. Enter >mngr< in the Station logon prompt and click OK.
5. Click Configure
⇒
Operator
⇒
Operators.
6. Click the mngr Operator ID.
7. Click Change Password.
8. Enter the New Password, Confirm the New Password and click OK.
Custom applications
Custom applications must be re-compiled and re-linked using
an appropriate development environment.
Navigate in Knowledge Builder to Application Development
Guide
⇒
About the Development Environment
⇒
Compiling,
Linking, and Editing for more information.
Quick Builder projects
When opening an old project file with the new version of
Quick Builder, you are prompted to migrate the project file to
the new format.
File dumps
Do not use any file dumps of the pre-upgrade database to
restore the upgraded database.
IMPORTANT
If you are renaming a redundant Server pair, you must
finish setting up redundancy before continuing.
Table 4.H Restoring ProcessLogix Data Considerations
Item
Post-upgrade