Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 211)

Publication 1757-IN500A-EN-P - September 2002
Supplementary Procedures 8-13
Installing and Running
NetShield with
ProcessLogix
Background
Problems with starting up and synchronizing Servers and crashing of
NetShield components can result from running the components concurrently
with the ProcessLogix software unless NetShield is specifically installed and
run as described in this section.
The problems noted above have occurred with version 4.5 of Network
Associates (formerly known as McAfee) NetShield, when running
automatically upon startup or during file access.
If the NetShield program is already installed on your ProcessLogix Server, go
to the next section to remove it. Otherwise, go to the section entitled Installing
NetShield and configuring directories for scan exclusion.
Removing Existing NetShield Installation
If NetShield is currently installed on the ProcessLogix Server, use the
following procedure to remove it.
1. Click Start
⇒
Settings
⇒
Control Panel.
2. Double-click the Add/Remove Programs icon.
3. Select NetShield and click Remove.
4. Click Yes to confirm the action and follow the on-screen instructions
on the Uninstall Wizard to remove the NetShield program.
5. Click Yes to restart the PC if prompted.
The PC must be restarted before continuing with the next section.
IMPORTANT
If you need to run the Network Associates NetShield 4.5
for NT and 2000 application on a ProcessLogix Server, you
must install and run the application as described in this
section.