Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 199)

1 Publication 1757-IN500A-EN-P - September 2002
Chapter
8
Supplementary Procedures
Stopping ProcessLogix
Applications and Services
This section describes how to stop ProcessLogix services in the Windows
2000 system. Use the following procedure to exit all ProcessLogix applications
and stop all ProcessLogix services.
1. Exit all running ProcessLogix applications, such as Control Builder,
Station, and Network Tools (NTOOLS).
2. Right click the My Computer icon and select Manage.
3. Expand Services and Applications.
4. Select Services.
1. Stop theses Services in the following order:
a. ProcessLogix Server Daemon (also stops ProcessLogix Server
Operator Management and ProcessLogix Server System, if
applicable)
b. ProcessLogix Server Database
c. ProcessLogix Server Logger
d. ProcessLogix Server Desktop
e. Windows Management Instrumentation
f. ProcessLogix Control Data Access Server
ATTENTION
!
Before installing or uninstalling any software component,
you MUST exit all ProcessLogix applications and stop all
ProcessLogix services.
If you have redundant servers, you must complete this
procedure on the SERVERB node first. Then complete
the entire procedure again for the SERVERA node.
TIP
To stop a service:
If the service is present, right-click on it and select Stop. If
prompted, click Yes to also stop other services. If a service
is already stopped, move on to the next one in the list
above.