Setting up secondary server (serverb), Making redundant hardware file entries, Configuring the time service – Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide User Manual
Page 165: Confirming data link is available, Setting up secondary server (serverb) -9, Making redundant hardware file entries -9

Publication 1757-IN500A-EN-P - September 2002
Additional Redundant Server Procedures 6-9
a. With the Full Mode version of the dialog box active, click the System
Running option.
b. Click Yes to confirm the action and wait for the Server to change its
state.
c. Close the ProcessLogix Server dialog box.
Setting Up Secondary
Server (SERVERB)
Use the following procedures to set up the Secondary SERVERB.
Making Redundant Hardware File Entries
Refer to Making Redundant Hardware File Entries on page 6-6 and repeat the
procedures on SERVERB. Change the reference in Step 1 from SERVERB
to SERVERA and in Step 2 from SERVERA to SERVERB. Be sure you are
working on the SERVERB.
Configuring the Time Service
1. Set up the time service on SERVERB.
Navigate in Knowledge Builder to Server and Client Configuration
Guide
⇒
Configuring and Monitoring Redundant Server System
⇒
Synchronizing
Date and Time on the Servers.
2. Click Start
⇒
Programs
⇒
ProcessLogix Server
⇒
Start-Stop
ProcessLogix Server to call up the ProcessLogix Server dialog box.
a. With the Full Mode version of the dialog box active, click the System
Running option.
b. Click Yes to confirm the action and wait for the Server to change its
state.
c. Close the ProcessLogix Server dialog box.
Confirming Data Link is Available
1. On SERVERA, click
Start
⇒
Run.
2. Enter this command:
>cmd<
and click OK to open the DOS window.