Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 143)

Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Client Installation and Upgrade Procedures 5-19
9. Click Next to accept ProcessLogix Client Software as the default
Program Folder for the Client software.
10. Review the software installation details summarized in the Confirmation
window.
• If you need to make changes, click Back to access any previous
entries.
• If the details are okay, click Next to begin the Client software setup.
This may take 10 to 15 minutes to complete.
11. Skip this step if the system does not include Excel Data Exchange.
Otherwise, click Enable Macros when requested.
12. At the Setup Complete window, click the No, I will restart my computer
later option and click Finish.
13. Click Next to install the ProcessLogix Update or the ProcessLogix
Operator Workstation Update.
14. At the ProcessLogix Update or ProcessLogix Operator Workstation
Update Complete window, click Finish.
If installing Engineering Workstation, wait until after the command
windows have closed and file copying is complete. This may take a few
minutes to complete.
15. At the ProcessLogix Setup Complete window, click the No, I will restart
my computer later option and click Finish.
16. Restart the PC.
TIP
If a Microsoft Excel dialog box appears, check the Do not
show this dialog again checkbox and click OK.
ATTENTION
!
In the next step, ignore the prompt to remove any disks.
The CD must remain in the CD-ROM drive. You must
select No in Step 12.